I installed some reflective rim tape on my Honda CBR 250R. An important step in the installation is prepping the rim to ensure that it is clean. This kit did not come with an application tool so I had to stick them on by hand. Tools I needed were shop towels, grime and grease remover, scissors, and a rear motorcycle stand. After installation, I tested how reflective it was at night.
Thanks to Jenny, Isabel, and Christi for helping me film the night ride footage.
Rating










Follow Me On:
-
Using Leftover Motorcycle Rim Tape
Sep, 26, 2014 -
Hot Bodies Modified Fender Eliminator – CBR2...
Sep, 26, 2014 -
Motorcycle Chain Cleaning & Maintenance ̵...
Sep, 25, 2014 -
DIY Oil Change on Honda CBR 250R
Aug, 26, 2015 -
Bar Ends Install – Honda CBR 250R Motorcycle
Sep, 25, 2014 -
Backfiring & Hesitation: Dirty Carbs? Nightha...
Apr, 04, 2015 -
Fix Hyper Flash Blinking with Load Resistors ̵...
Oct, 10, 2014 -
How to Use Seafoam on a Motorcycle with Carbs R...
Apr, 08, 2015 -
Clean & Lubricate Tachometer Cable – Ni...
Apr, 21, 2015 -
Motorcycle Air Filter Inspection & Replacemen...
Sep, 26, 2014